Ad-is air dryer manual

W_1_ 5. 1About This Manual. This manual enables safe and efficient handling of the device. This manual is an integral part of the device, and must be kept in close proximity to the device where it is permanently accessible to personnel. In addition, instructions concerning labor protection laws, operator regulations tools and supplies must be available and adhered to. It provides clean, dry air to the components of the brake system which increases the life of the system and reduces maintenance costs. Daily manual draining of the reservoirs is eliminated. The AD-IP ™ air dryer consists of a desiccant cartridge secured to a die cast aluminum end cover with a single, central bolt. FIGURE 2 - BENDIX® AD-IS® AIR DRYER SYSTEM SCHEMATIC Note: The Bendix ® AD-IS air dryer purge piston has a purge control channel drain. This allows any condensation in this area to flow past a diaphragm in the top of the purge piston and out through a channel in the middle of the central bolt of the purge assembly to be drained.

dryer AI - Air Intake located on the top of right side of the unit AD - Air Discharge located on the bottom right side of the unit Ducting of air is optional Capacity per cycle 96 full face masks half masks Twelve 20" x 20" x 7"(H) Baskets* *Baskets are included Air Flow CFM Heater kW Watts Electrical 1. 8 feet, 10 AWG, 3 wire. Haldex product 'Bendix® AD-9' (X): Bendix® AD-9, Competitive (New/Remanufactured), Air Dryers, Air Dryer/Air Line We are doing scheduled site maintenance. The site may feel slow and unresponsive at times. Operation panel AD hygrostat control The air dryers of the AD-series dispose of a hygrostat for setting the required humidity value. This hygrostat is located in the front of the unit. It makes that the air dryer cuts in as soon as the ambient humidity exceeds the preset value. If the.

FIGURE 2 - BENDIX® AD-IS® AIR DRYER SYSTEM SCHEMATIC Note: The Bendix ® AD-IS air dryer purge piston has a purge control channel drain. This allows any condensation in this area to flow past a diaphragm in the top of the purge piston and out through a channel in the middle of the central bolt of the purge assembly to be drained. • Blower purge dryers use a combination of air from an external blower, heat and minimal compressed air. CD The drying process 1 Wet compressed air flows upward through the desiccant which adsorbs the moisture, from bottom to top. The regeneration process 2 Dry air from the outlet of the drying tower is expanded to atmospheric pressure and. Daily manual. draining of the reservoirs is eliminated. ™. The AD air dryer consists of a desiccant cartridge and a. die cast aluminum end cover secured to a cylindrical steel. outer shell with eight cap screws and nuts. The end cover. contains a check valve assembly, a safety valve, three.