Gill windsonic manual

• If the WindSonic is to be installed at heights over 2 m (6 ft), be familiar with tower safety and follow safe tower climbing procedures. • DANGER—Use extreme care when working near overhead electrical. If the WindSonic is to be installed at heights over 2 m (6 ft), be familiar with tower safety and follow safe tower climbing procedures. DANGER—Use extreme care when working near overhead electrical wires. Check for overhead wires before mounting the WindSonic or before raising a tower. With WindSonic power off, set up a Terminal connection but with the Baud rate set to (this can be at variance with the original WindSonic Baud rate setting). Page Alibration WindSonic to view data. Calibration A Custom calibration is available from Gill Instruments.

Note: The default configuration of the Gill WindSonic Opt 3 sensor is compatible with the RX station as depicted in this instruction. No changes to the as-received configuration are required. Portions of the Gill WindSonic Technical Manual are used within this application note, but the full manual is. A lightweight unit, the WindSonic Ultrasonic Anemometer, manufactured by Gill Instruments, is of a robust, high strength www.doorway.rut the need for expensive on-site calibration or maintenance, and with a corrosion free exterior, the Gill UltraSonic Anemometer WindSonic is a true fit and forget unit. Gill WindSonic Anemometer. The WindSonic wind speed and direction sensor range utilise proven ultrasonic technology from Gill Instruments. This 2-axis ultrasonic wind sensor has no moving parts and is maintenance-free and easy to install. The WindSonic is compatible with RPR's SpaceLogger data loggers and the WeatherFile Communication Unit (WCU.

Overview Wind is a PC application which can be used to configure Gill wind sensors. Compatible Products The Wind application is compatible with the following products: WindSonic (serial numbers or higher) WindMaster; WindMaster Pro; WindMaster HS. If the WindSonic is to be installed at heights over 2 m (6 ft), be familiar with tower safety and follow safe tower climbing procedures. DANGER—Use extreme care when working near overhead electrical wires. Check for overhead wires before mounting the WindSonic or before raising a tower. The Gill WindSonic is a low-cost anemometer, which utilises Gill’s proven ultrasonic technology to provide wind speed and direction data via one serial or two analogue outputs. To confirm correct operation, outputs are transmitted together with an instrument status code. With a robust, corrosion-free polycarbonate housing, this small, lightweight.